December 18th, I’m looking to control it through VB, partly as a programming excercise, and because I kinda doubt there are cheaper ways of doing it. Have you considered discrete control of the drive? Also, anyone automating a holiday display? Find More Posts by hkg.
|Date Added:||11 March 2010|
|File Size:||9.68 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
It’s not in English so I can’t read it I’m looking to control it through VB, partly as a programming excercise, and because I kinda doubt there are cheaper ways of doing it.
It’s basically a superset of Modbus RTU. September 25th, However, they also could not answer.
Sign In Sign Up. You are not registered yet.
Allen Bradley USB Drivers – – Interactive Q & A
Seven things you need to know about the PanelView Plus. Anyway, you select ok in the workstation. I’d like to be able to rlinx a file of the parameters, have a good interface with sliders that I can easily change, etc. As it stands, this one powerflex is used on a LOT of different equipment, from stirring machines, to lathes, mills, and grinders, so going through rsinx the parameters on the blasted keypad takes forever, if I could control it via a VB.
USB Cables For Use With Allen-Bradley (A-B) Products
Click HERE to post a comment or question. I’m going to have to do some relearning Thanks. The driver is in the lap top an I have Studio complete and activated, but the manager devices of windows 10 sen this message. Communicate and Download over Data Highway Plus using What’s New with Logix and Rsilnx
Here is what I did. Do I need a termination resistor? The electrical wiring standard is the same, but the protocol is different. From what I am reading, I should be able to make a connector cable using only pins 4 and Sincerely, Shawn Tierney If you enjoyed reading my article you may also like my affordable training courses at TheAutomationSchool. The problem I have with a discrete IO board is I wouldn’t be able to control ramp times, etc, and it would be a lot more limited.
If it works through a COM port, I ought to be able to do it, I will have to create the packets according to the protocol indeed for it to be understood, but I dont’ think that’s rocket science as long as there’s documentation. Started by Nesikep21 Nov Data Highway Plus to Ethernet video.
After this, you only have to select “Conect to Drive”, or if you have the option of select a drive even if is not the drive that you want to conect in that tab, select it. Anyone know of a driver or library that can act as a go-between?
Part 2 is going to be harder. Have you considered discrete control of the drive? If you enjoyed reading my article you may also like my affordable training courses at TheAutomationSchool. Consider this other alternative Thanks for the tip!
Do you know, how I can get the driver? The long and the short of it is I have one drive doing a lot of things, sometimes it’s doing step logic, and with a bunch of different parameters, other times it will run a PID loop, all depending on what it’s connected to.
Scripting must be enabled to use this site.
The newest version of this article is located HERE […]. Sign up for a new account in our community.
Click here now to try it.